No eBay APP ID and/or Cert ID defined in Kunena configurationNo eBay APP ID and/or Cert ID defined in Kunena configuration
A place for general chat about the Jimny. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.
Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message
Suppliers or Members who have contributed to the forum can be identifed by the
No eBay APP ID and/or Cert ID defined in Kunena configuration
Having discovered the vacuum pipes look in a bad state, I've decided to replace them with new, and came across these on ebay. Has any one replaced their pipes with this blue silicon pipework. Did you find it was up to the job.
Is it a diificuit job to do ?
No eBay APP ID and/or Cert ID defined in Kunena configurationReplied by mlines on topic Vacuum pipes rusted.
If its soft silicon will it not collapse under the vacuum. Surely a rigid or semi-rigid pipe is better?
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
No eBay APP ID and/or Cert ID defined in Kunena configurationReplied by BGBrit on topic Vacuum pipes rusted.
Hi Martin,
I did write to your store if they could supply me wih new vac pipes a few days ago, I'm having two sets of King pin bearing sent over from you at the moment, will arrive soon to Bulgaria, I just noticed my vac pipes are pretty worn while I was preparing for the King pins bearing work.
I'd rather use orginal parts if you can supply them..As I take your point on soft material.
No eBay APP ID and/or Cert ID defined in Kunena configurationReplied by mlines on topic Vacuum pipes rusted.
Yes, I don't do these pipes. I was just emphasising to check that they will take the vacuum.
THe vacuum is quite low - 5.7 PSI or 40Kpa is the minimum for the system but I would ask the vendor what the hose is specified to.
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
It looks like people use it for mechanical boost gauges that display between -1 and +2 BAR which is over 14psi of vacuum at the lower extreme which suggests its ok for 5 PSI of vacuum
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
We use cookies to give you the best online experience. Please let us know if you agree to all of these cookies. Accepting the Cookies also accepts the Disclaimers for the website.
logo.
