A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
PS I changed my races and king pin bearings without going near the main bearing as it was fine. The hub swung off and away pivoting on the tie rod end, just sat it on some blocks. Races came out with a good smack, use old race on top of new to hit with hammer. And a good dollop of grease to hold the bottom bearing in while I swung hub back round and over the knuckle. Easy.
We use cookies to give you the best online experience. Please let us know if you agree to all of these cookies. Accepting the Cookies also accepts the Disclaimers for the website.
