A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
How to replace a Universal Joint
10 years 7 months ago #165362
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
How to replace a Universal Joint was created by mlines
Thanks to Maverick of this forum, a new how-to has been uploaded
www.bigjimny.com/index.php/information/q...ask=weblink.go&id=72
www.bigjimny.com/index.php/information/q...ask=weblink.go&id=72
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
The following user(s) said Thank You: maverick
Please Log in or Create an account to join the conversation.
10 years 7 months ago #165363
by Halford
Replied by Halford on topic How to replace a Universal Joint
Nice one Brett 
I'll keep it handy for my man servant as a future task.
Stick a post below for [strike]gratification[/strike] thanks button presses
I'll keep it handy for my man servant as a future task.
Stick a post below for [strike]gratification[/strike] thanks button presses
Please Log in or Create an account to join the conversation.
- mickt
- New Member
-
Less
More
- Thank you received: 0
10 years 7 months ago #165416
by mickt
Replied by mickt on topic How to replace a Universal Joint
One important point to remember is the bearings in the cap are only held in place when removed from the cross piece with the grease and are easily dislodged if not kept level and are a b****r to get back in place so plenty of grease and ultra caution and steady hands are essential!
Please Log in or Create an account to join the conversation.
Time to create page: 0.075 seconds
