A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Grinding, After a jimnybits 3"lift
- DIG5069
- Topic Author
- New Member
-
Public
24 Jul 2013 20:49 #78117
by DIG5069
Replied by DIG5069 on topic Grinding, After a jimnybits 3"lift
No probs (sorry i read it wrong) my bad :blush:
Its been a long day on with my jim, lol its gonna be checked the morning
Cheers keith
Its been a long day on with my jim, lol its gonna be checked the morning
Cheers keith
Please Log in or Create an account to join the conversation.
- helijohn
- New Member
-
Public
- DIG5069
- Topic Author
- New Member
-
Public
25 Jul 2013 21:34 #78224
by DIG5069
Replied by DIG5069 on topic Grinding, After a jimnybits 3"lift
Thanks for all the help Markyp2000 & Heiljohn. Both front backplates were bent out over and touching the disk,
I am guessing this was done when i had the castor arms off doing the bushes, (the axle was resting on the floor) lol :blush:
As Helijohn says...They got a re-design with a big hammer :laugh:
Other than that my jim rides like a new car! No crashing with potholes or bumps
Just a few more bits to do when i have the $$$ and i'll be a happy chappy!
Thanks again, Keith
I am guessing this was done when i had the castor arms off doing the bushes, (the axle was resting on the floor) lol :blush:
As Helijohn says...They got a re-design with a big hammer :laugh:
Other than that my jim rides like a new car! No crashing with potholes or bumps
Just a few more bits to do when i have the $$$ and i'll be a happy chappy!
Thanks again, Keith
Please Log in or Create an account to join the conversation.
- darthloachie
- New Member
-
Public
Time to create page: 0.168 seconds