×
BigJimnyMeet (North) 2024 (12 Jan 2024)
BigJimnyMeet 2024
14th July 2024
Parkwood Nr. Leeds
14th July 2024
Parkwood Nr. Leeds
Booking now open - Discount for additional vehicles
Click HERE for details
Click HERE for details
×
A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
OilRe:Jimny 2010 rear axle leaking again after few months
- Jeep4life
- Topic Author
- Visitor
-
Public
15 Apr 2019 07:30 #206129
by Jeep4life
Jimny 2010 rear axle leaking again after few months was created by Jeep4life
HI,
few months ago i replaced the whole set on both sides on the rear axle,
oil seal, bearing, and ABS ring.
now i noticed two weeks ago that the left side is leaking again, and today i saw that the right side is also started even bigger leak.
for the parts i used SKF kit. its been barley 2000 KM since i changed everything. what can be the reason for that? and what i should do?
Thanks.
few months ago i replaced the whole set on both sides on the rear axle,
oil seal, bearing, and ABS ring.
now i noticed two weeks ago that the left side is leaking again, and today i saw that the right side is also started even bigger leak.
for the parts i used SKF kit. its been barley 2000 KM since i changed everything. what can be the reason for that? and what i should do?
Thanks.
Please Log in or Create an account to join the conversation.
15 Apr 2019 09:47 #206134
by Jezz
It's been fettled just a tad.
Replied by Jezz on topic Jimny 2010 rear axle leaking again after few months
My first thought was, Is the axle case bent?
It's been fettled just a tad.
Please Log in or Create an account to join the conversation.
- Jeep4life
- Topic Author
- Visitor
-
Public
16 Apr 2019 05:07 #206170
by Jeep4life
Replied by Jeep4life on topic Jimny 2010 rear axle leaking again after few months
Hi Jezz,
nope, the case looks good
nope, the case looks good
Please Log in or Create an account to join the conversation.
16 Apr 2019 05:41 #206171
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic Re:Jimny 2010 rear axle leaking again after few months
Is it offroaded?
Sent from my Pixel 2 XL using Tapatalk
Sent from my Pixel 2 XL using Tapatalk
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
- Jeep4life
- Topic Author
- Visitor
-
Public
16 Apr 2019 07:07 #206183
by Jeep4life
Replied by Jeep4life on topic Re:Jimny 2010 rear axle leaking again after few months
Hi Mlines,
this jimny is most of the time offroading. it has 215 tires and lockright locker.
the whole set was replaced both sides 6 month ago..
this jimny is most of the time offroading. it has 215 tires and lockright locker.
the whole set was replaced both sides 6 month ago..
Please Log in or Create an account to join the conversation.
16 Apr 2019 07:19 #206184
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic Re:Jimny 2010 rear axle leaking again after few months
To be honest, 6 months out of a set of bearings on an off-roaded Jimny is probably about average.
The rear bearing design on a Jimny is poor, with the bearing face basically exposed. When you replace them you are supposed to put sealant around the face to try and assist with the sealing but it is not particularly effective.
A bent axle case or bent half shaft is quite likely, its not a visible bend but one that has to be measured.
The rear bearing design on a Jimny is poor, with the bearing face basically exposed. When you replace them you are supposed to put sealant around the face to try and assist with the sealing but it is not particularly effective.
A bent axle case or bent half shaft is quite likely, its not a visible bend but one that has to be measured.
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
- Jeep4life
- Topic Author
- Visitor
-
Public
16 Apr 2019 07:40 #206186
by Jeep4life
Replied by Jeep4life on topic Re:Jimny 2010 rear axle leaking again after few months
well to be honest i didnt put the sealant after the change, because i was scared i will open the wheel again.
the last bearings was the originals i think.. and they was ok for 2 years of heavy ofroad + 6 years of regular use..
the SKF bearings really that trash ? it doesn't make any sense to replace the whole set twice a year :\
how can i measure if the case is bent ?
the last bearings was the originals i think.. and they was ok for 2 years of heavy ofroad + 6 years of regular use..
the SKF bearings really that trash ? it doesn't make any sense to replace the whole set twice a year :\
how can i measure if the case is bent ?
Please Log in or Create an account to join the conversation.
- Jeep4life
- Topic Author
- Visitor
-
Public
18 Apr 2019 09:38 #206321
by Jeep4life
Replied by Jeep4life on topic Re:Jimny 2010 rear axle leaking again after few months
anything else i can look for when im looking on the open axle?
Please Log in or Create an account to join the conversation.
18 Apr 2019 09:43 #206322
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic OilRe:Jimny 2010 rear axle leaking again after few months
Oil splash protectors in place?
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
- Jeep4life
- Topic Author
- Visitor
-
Public
18 Apr 2019 10:14 #206324
by Jeep4life
Replied by Jeep4life on topic OilRe:Jimny 2010 rear axle leaking again after few months
will check.
they are important? i dont even remember what i did with those.
Thanks!
they are important? i dont even remember what i did with those.
Thanks!
Please Log in or Create an account to join the conversation.
Time to create page: 0.110 seconds