×
A place for general chat about the Jimny. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.
Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message
Suppliers or Members who have contributed to the forum can be identifed by the
logo.
Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.
Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message
Suppliers or Members who have contributed to the forum can be identifed by the
Jimny commercial
03 Jul 2021 15:53 #236351
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic Re:Re:Jimny commercial
It looks to be a straight fit.
Each picture below shows the SZ5 point followed by the commercial fitting point.
So at the floor it fits where there is a blanking plug on the sz5.
Halfway up it fits to the first blanking plug under the window.
At the top it fits to the first fitting for the rear grab handle
Sent from my moto g(8) power using Tapatalk
Each picture below shows the SZ5 point followed by the commercial fitting point.
So at the floor it fits where there is a blanking plug on the sz5.
Halfway up it fits to the first blanking plug under the window.
At the top it fits to the first fitting for the rear grab handle
Sent from my moto g(8) power using Tapatalk
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
05 Jul 2021 07:20 #236406
by DAGZOOK
Yikes that's awfully expensive. It's perhaps too early in the commercials life to be chasing spare parts down at a reasonable cost from the dealership. Perhaps I'll have to hold out for a second hand one should any commercial owners want to sell their bulkhead.
Replied by DAGZOOK on topic Re:Re:Jimny commercial
Please Log in or Create an account to join the conversation.
Time to create page: 0.194 seconds