A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

Steering Box seals and rebuilding

Jim Jim
Topic Author
New Member
Public

17 May 2019 15:22 #208210 by Jim Jim

Steering Box seals and rebuilding was created by Jim Jim

Hi Guys,
I searched here for info but did not find anything.
Has anyone replaced their Jimny 3 steering box seals? Mine is leaking and I would like to know if anyone did and your thoughts. I should look for workshop manuals for this Jimny too.

I have seen a few seal kits like this one www.superspares.com.au/power-steering-bo...r-suzuki-jimny-10-19
Please advise.
Thanks.

Please Log in or Create an account to join the conversation.

Lambert
Offline
Moderator
Registered
The quickest Jimny in Harrogate...(that I own)

17 May 2019 15:30 #208211 by Lambert

Replied by Lambert on topic Steering Box seals and rebuilding

Never done a Suzuki one. But I have been inside a land rover one. Bit of a pig of a job. If i had to do it again I would send it to a specialist.

Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
Bellerophon (2024 grello van daily
ADOS Attention Deficit Ooooh Shiny!

Please Log in or Create an account to join the conversation.

Jim Jim
Topic Author
New Member
Public

17 May 2019 16:56 #208220 by Jim Jim

Replied by Jim Jim on topic Steering Box seals and rebuilding

I am rebuilding/modifying my 1997 LR Defender 110 hard top and had the steering box rebuilt too, it is a bit of a pain indeed, heavy too.

From what I read, the Jimny's steering box had a lot of ball bearings, not sure how deep you have to go to change the seals.

Please Log in or Create an account to join the conversation.

Time to create page: 2.613 seconds

Steering Box seals and rebuilding

Events Menu