Jimny bits lift springs

i had the 2" lift fitted on the jim from jimny bits when off roading last week snapped a spring so seen this as an opportunity to get some more lift and go for a bigger set of springs the +3"

the new springs arrived this week so got around to fitting them pulled the springs off the truck and measured them up with the new ones and there is no visible difference between the two??

is it the stiffness between the two springs the difference because there is no difference in length...



top spring has the front +3 stamped on it
where the bottom has the +2 stamped on it

You need to email rus maybe he got some of his stock mixed up as I'm waiting for the 2" lift to come in.
Or was yours a 3" lift in the first place

DIRTYDOGZ

i originally had the 2" then ordered the 3"

was just expecting a noticeable difference between the two...

just counted the coils on the springs in ur photo, one has more than the other, that could be the difference?

In photo the old 2" spring has more coils than the new spring is that the o/s side and the new one a n/s.

yeh the 2" has more coils? would have thought the 3" would have had the more coils...

dirtydogz wrote: In photo the old 2" spring has more coils than new spring is that the o/s side and the new one a n/s.

No these were both the drivers side springs ie the longest of the 4 in the kit compared with the +2" spring that was taken off of the drivers side.

Have you got a photo of all the new spring as this might help, and is that the only old spring that you have removed,