What did you do to your jimny today?

Fitted raptor4x4 roof rack, just need to sort CB antenna mount

Sent from my 2201116SG using Tapatalk

Fitted improved brakes from Martin's shop.  No more warped thin discs causing death wobble when braking. 

Centre DTM exhaust going through number plate location

Nearly there

Looks good.
Is the number plate going to get located on the spare wheel blank cover?

Thank you, I am thinking of getting a square one made up and putting it below the Jimny spare wheel blanking cover. Need to put some LED’s to make it legal. Noticed the exhaust is illuminated in the dark with the old number plate lights.

spray paint for the cover also arrived today. debated if I should leave it black but reckon it will look much better silver and make the Jimny logo pop out.

Sprayed the HD prop Shafts red

Sent from my 2201116SG using Tapatalk

Fitted front runner roof rack ☺️

Sent from my 2201116SG using Tapatalk

Installed the latest version of OSMAnd (Sat Nav, Open Street Maps) in to my Android head unit.

I have used OSMAnd for a while now as it allows your own GPX routes to be added and you can download all of the Byways, etc for your region from www.rowmaps.co.uk), but it wasn't until the latest release that the Android version allowed the 2.5D (driving) view.

The screen is clear, bright, easy to see and the guidance (voice) pretty much standard.
 

Once you have your favourite off road routes added, it will even give you route guidance to the start and very likely as you drive along, at least it will show you if you are still on route.

Best of all it is free for 7 maps (each detailed UK region is 1 map) and there is a paid for version above this, but it's not expensive.  Also runs on iPhone if you just want to use it on your mobile.

Robin
 

Finished off fitting 2 front wheel bearings. Easier than I thought it would be. Back ones will need done shortly as well tho.

Fitted a new squib to the steering wheel to get rid of the dash warning light.  Think the old squib was past repairing after repairing 2 times previous.

Fitted new abs sensor wires to get rid of the other warning light.  Cheapo cable off eBay, 

Fitted the jimny lean correction bump stop to the right front spring and it's looking a lot better

Finally today started to fit my new EBC disks and pads. The one being removed have just over 30k of very light use, but for sometime they have felt warped. You can see the problem in the surface of one, result of something else or just poor quality control?
These are Elcher from a car part supplier, very cheap at £25 each, so I guess you get what you pay for.