A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Torque Wrench
- jackonlyjack
-
Topic Author
- Offline
- Platinum Member
-

Registered
Less
More
- Posts: 3111
- Thank you received: 706
14 Jan 2017 19:03 #176808
by jackonlyjack
Torque Wrench was created by jackonlyjack
Hi all can anyone tell me if anything on the jimny requires more than 200Nm
as i need to buy a new wrench
Jack
as i need to buy a new wrench
Jack
The following user(s) said Thank You: kirkynut
Please Log in or Create an account to join the conversation.
14 Jan 2017 19:12 #176809
by kirkynut
The underdog often starts the fight, and occasionally the upper dog deserves to win - Edgar Watson Howe.
My Jimny Thread Here: www.bigjimny.com/index.php/forum/8-my-ji...on-continues?start=0
Replied by kirkynut on topic Torque Wrench
The front wheel bearings have to be done up a bit tighter I think but I've always been alright going as far as my torque wrench can plus a smidgen. So I would say that is fine!
Kirkynut
Kirkynut
The underdog often starts the fight, and occasionally the upper dog deserves to win - Edgar Watson Howe.
My Jimny Thread Here: www.bigjimny.com/index.php/forum/8-my-ji...on-continues?start=0
The following user(s) said Thank You: jackonlyjack
Please Log in or Create an account to join the conversation.
- petejones69
- New Member
-

Public
Less
More
- Thank you received: 0
15 Nov 2017 19:30 #186291
by petejones69
Replied by petejones69 on topic Torque Wrench
I need to buy a torque wrench - can anyone recommend one? Halfords do a couple, but they cost £80 each :ohmy:
Please Log in or Create an account to join the conversation.
- jackonlyjack
-
Topic Author
- Offline
- Platinum Member
-

Registered
Less
More
- Posts: 3111
- Thank you received: 706
15 Nov 2017 19:48 #186293
by jackonlyjack
Replied by jackonlyjack on topic Torque Wrench
The following user(s) said Thank You: petejones69
Please Log in or Create an account to join the conversation.
Time to create page: 0.085 seconds
