A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Need Help please
- chriscallow
- Topic Author
- New Member
-
Less
More
- Thank you received: 0
11 years 2 months ago #151398
by chriscallow
Need Help please was created by chriscallow
jimny keeps cutting out at a constant speed, say if i was going 60mph it will start to cut out and jolt around, then the rev needle goes mad, so i pull up turn if off and start it again then it runs fine. so i dont know what is up with it, it hasnt been serviced in a wile i dont know if thats some think to do with it
i would appreciate the help :laugh:
i would appreciate the help :laugh:
Please Log in or Create an account to join the conversation.
11 years 2 months ago #151416
by j999pre
Gold Jimny the best colour (sold)
Big red Jimny 32" tyres, arbs, cage 5:1 transfer etc. (Sold)
Grey pick up Jimny
Turbo m13a, arbs, floating rear shafts, disc conversion rear, vented front conversion. 245 70 16. Winch, 3" lift, 4:16 trans hd shafts and CVS
Replied by j999pre on topic Need Help please
M13a engine? Probably crank sensor behind alternator
Gold Jimny the best colour (sold)
Big red Jimny 32" tyres, arbs, cage 5:1 transfer etc. (Sold)
Grey pick up Jimny
Turbo m13a, arbs, floating rear shafts, disc conversion rear, vented front conversion. 245 70 16. Winch, 3" lift, 4:16 trans hd shafts and CVS
Please Log in or Create an account to join the conversation.
Time to create page: 0.079 seconds
