A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Power steering pump renew , how to bleed
- miktt100
- Topic Author
- New Member
-
Public
- idiotmobil
- New Member
-
Public
26 Mar 2014 16:49 #110155
by facade
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Replied by facade on topic Power steering pump renew , how to bleed
The engine has to be running at idle. :whistle:
Lock to lock with the wheels off the floor or you will dig your drive up, or wear flats on the tyres.
When the fluid isn't foamy, it is done
Keep topping up as required.
I remember doing this on an old Rover once, with the reservoir part of the pump, and for convenience I left the lid off. All the foamy fluid shot out and got everywhere. :ohmy:
Lock to lock with the wheels off the floor or you will dig your drive up, or wear flats on the tyres.
When the fluid isn't foamy, it is done
Keep topping up as required.
I remember doing this on an old Rover once, with the reservoir part of the pump, and for convenience I left the lid off. All the foamy fluid shot out and got everywhere. :ohmy:
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Please Log in or Create an account to join the conversation.
- miktt100
- Topic Author
- New Member
-
Public
Time to create page: 0.146 seconds