A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Dashboard screw location etc (changing HM)
- piprice
- Topic Author
- New Member
-
Public
Less
More
- Thank you received: 0
26 Oct 2013 19:15 #88080
by piprice
Dashboard screw location etc (changing HM) was created by piprice
Taking the dash out tomorrow to replace the heater matrix had enough of the crappy 12v heater that does nothing and the dangerous after mess of wiping the window with the sponge thing!
Currently bypassed and have the HM and blower so need to remove dash I've seen silver jimny and photos are not to clear...
Just wondering if there's a sequence and where the screws are?
Does the dash split in two or is it a whole complete dash...
No it's a bugger if a job but me and my bro in law are tackling well he'll start whilst I replace breaks and lambda and rocker cover gasket
Any advice is appreciated
Currently bypassed and have the HM and blower so need to remove dash I've seen silver jimny and photos are not to clear...
Just wondering if there's a sequence and where the screws are?
Does the dash split in two or is it a whole complete dash...
No it's a bugger if a job but me and my bro in law are tackling well he'll start whilst I replace breaks and lambda and rocker cover gasket
Any advice is appreciated
Please Log in or Create an account to join the conversation.
- helijohn
- New Member
-
Public
Less
More
- Thank you received: 0
26 Oct 2013 20:01 #88094
by helijohn
It would be good to take and post some pics as you go unless there is a pic guide on here already. Good luck with the job.
Replied by helijohn on topic Dashboard screw location etc (changing HM)
piprice wrote: Taking the dash out tomorrow
It would be good to take and post some pics as you go unless there is a pic guide on here already. Good luck with the job.
Please Log in or Create an account to join the conversation.
- piprice
- Topic Author
- New Member
-
Public
Less
More
- Thank you received: 0
26 Oct 2013 20:05 #88096
by piprice
Replied by piprice on topic Dashboard screw location etc (changing HM)
I think I'll be to busy doing the brakes, lambda and rocker cover lol, my brother in law said just cut the dash out and leave it out lol, he deals with banger cars! But I think id rather not and keep it looking sellable for the future lol
Please Log in or Create an account to join the conversation.
- helijohn
- New Member
-
Public
Less
More
- Thank you received: 0
26 Oct 2013 20:14 #88099
by helijohn
Did that once with a Ford Anglia dash. It's my philosophy that I like easy access so once something is off it might not go back. LOL
Shame about the pics though.
Replied by helijohn on topic Dashboard screw location etc (changing HM)
piprice wrote: I think I'll be to busy doing the brakes, lambda and rocker cover lol, my brother in law said just cut the dash out and leave it out lol, he deals with banger cars! But I think id rather not and keep it looking sellable for the future lol
Did that once with a Ford Anglia dash. It's my philosophy that I like easy access so once something is off it might not go back. LOL
Shame about the pics though.

Please Log in or Create an account to join the conversation.
Time to create page: 0.152 seconds