A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
manual locking hubs .
10 Jun 2012 06:43 #42108
by robs5230
standard jimny - for now
manual locking hubs . was created by robs5230
i was going to permanently lock my auto hubs ( removing vac pipes and manually locking the collars ) but i have managed to source a pair of aisin manual hubs complete with the bolts and cone washers 
does anyone have any suggestions about stripping , cleaning , regreasing etc before i fit ??
i will be ordering the adapter plates shortly from martin.
also when fitting the hubs should the jim be in 2wd , 4wd and should the hubs be locked or unlocked ??
cheers rob
does anyone have any suggestions about stripping , cleaning , regreasing etc before i fit ??
i will be ordering the adapter plates shortly from martin.
also when fitting the hubs should the jim be in 2wd , 4wd and should the hubs be locked or unlocked ??
cheers rob
standard jimny - for now
Please Log in or Create an account to join the conversation.
10 Jun 2012 07:14 #42109
by facade
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Replied by facade on topic Re: manual locking hubs .
Clean & lubricate.
There is a youtube video, but here is a web page
forum.ih8mud.com/79-95-toyota-truck-tech...ing-hub-rebuild.html
You fit the outside part then the centre has to be fitted correctly: some of the lugs are larger than the others.
Best done in 4wd, then you can jack up a front wheel and see if they locked.
There is a youtube video, but here is a web page
forum.ih8mud.com/79-95-toyota-truck-tech...ing-hub-rebuild.html
You fit the outside part then the centre has to be fitted correctly: some of the lugs are larger than the others.
Best done in 4wd, then you can jack up a front wheel and see if they locked.
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Please Log in or Create an account to join the conversation.
Time to create page: 0.173 seconds