A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
King Pins and Bearings
21 Jul 2010 12:08 - 21 Jul 2010 12:08 #3927
by MigCooper
_________________________________________
Snorkel and plenty of rust to be treated
_________________________________________
Replied by MigCooper on topic Re:King Pins and Bearings
Hi ooky
I found they are quite easy to do, but requires some tools and is a very messy job.... loads of grease everywhere.
You can find a manual in the Here .. Number 4 on the list
You will need a puller at least a 1 E10 socket...
Regards
I found they are quite easy to do, but requires some tools and is a very messy job.... loads of grease everywhere.
You can find a manual in the Here .. Number 4 on the list
You will need a puller at least a 1 E10 socket...
Regards
_________________________________________
Snorkel and plenty of rust to be treated
_________________________________________
Last edit: 21 Jul 2010 12:08 by MigCooper.
Please Log in or Create an account to join the conversation.
Time to create page: 0.161 seconds