Search results
Jump to navigation
Jump to search
Create the page "Rod" on this wiki! See also the search results found.
Page title matches
- If Jimny is regularly used on gravel or off road, original (OEM) tie rod ends typically prove significantly more durable than aftermarket ones. Since wheel alignment has to be performed (and paid for) after each tie-rod end change, it definitely pays off to use the best ones - OEM!423 bytes (64 words) - 13:31, 17 January 2021
- Yet another source of poor steering on a Jimny is a worn tie rod / track rod end. ...lacement guide - figure 01.jpg|thumb|left|640px|Figure 01 - checking a tie rod end]]4 KB (632 words) - 13:32, 17 January 2021
Page text matches
- If Jimny is regularly used on gravel or off road, original (OEM) tie rod ends typically prove significantly more durable than aftermarket ones. Since wheel alignment has to be performed (and paid for) after each tie-rod end change, it definitely pays off to use the best ones - OEM!423 bytes (64 words) - 13:31, 17 January 2021
- Yet another source of poor steering on a Jimny is a worn tie rod / track rod end. ...lacement guide - figure 01.jpg|thumb|left|640px|Figure 01 - checking a tie rod end]]4 KB (632 words) - 13:32, 17 January 2021
- | Radius arm / radius rod / torque arm | Radius arm / radius rod / torque arm || http://en.wikipedia.org/wiki/Radius_rod || || Längslenke3 KB (350 words) - 09:15, 19 April 2018
- ...your hand to unscrew the plastic cap/pin on the interior rear door locking rod. ...ff from the door (while being careful about the interior rear door locking rod).4 KB (631 words) - 08:22, 27 November 2019
- * Take a long wooden or metal rod (for example a long screwdriver or a long wrench) and put it against variou *** Be careful not to "slide" the rod around!3 KB (555 words) - 13:53, 21 February 2019
- The idea is to weld a short steel rod between the tow bar and the existing factory rear tow point. This way, the Then that rod can be used as a base for attaching a bow shackle or a hook.9 KB (1,480 words) - 13:02, 17 January 2021
- * Front lateral ("panhard") rod is different. * The rear lateral rod is the same.7 KB (1,138 words) - 07:12, 25 July 2019
- |Tie-Rod End Nut |Gear shift rod spring / ball bearing bolts4 KB (451 words) - 10:59, 11 August 2020
- # Check for worn tie rod ends. # Check for worn lateral (panhard) rod bushes.41 KB (6,917 words) - 12:17, 5 December 2021
- * If you lift the shift rod it will probably pop off a synchro sleeve on the input shaft, and synchro k * You could tap the bearings on with a brass rod and a hammer.10 KB (1,847 words) - 13:59, 21 February 2019
- ...and rear radius arms, front and rear panhard rods, front tie rods and tie rod ends, all coil springs, all shock absorbers, etc. {{note|The front panhard rod and the rear coil springs differ between LHD and RHD Jimnys (more details i33 KB (5,492 words) - 09:24, 18 November 2020
- ...r side of each rear seat's backrest, and there is a short horizontal metal rod in the middle of each hole;6 KB (944 words) - 06:13, 12 August 2021
- ...with the adjuster. Make a careful note of how the adjuster is fitted, the rod has a forked end and on part of the fork has a step in it. Make careful not7 KB (1,279 words) - 19:32, 3 February 2017
- * The rod has a forked end and on part of the fork has a step in it.8 KB (1,504 words) - 14:13, 21 February 2019
- |Holds the hood's support rod in place when it is in resting position; |Holds the hood's support rod in place when it is in resting position;30 KB (4,250 words) - 13:15, 26 April 2022
- * The rod has a forked end and on part of the fork has a step in it.11 KB (1,932 words) - 16:20, 4 November 2021
- * Insert the brake carefully in the drum along with the hex rod into the gear box.12 KB (2,143 words) - 08:05, 27 February 2019
- ...e con rods and the crank were poorly designed and tend to spin between the rod and the crank. *** It appears that replacing the connection rod plates might actually be a major undertaking regarding the amount of labor.81 KB (12,996 words) - 13:06, 13 December 2021
- * Remove gear shift control joint bolt and extension rod bolt.18 KB (3,128 words) - 13:34, 21 February 2019
- ...layed about with trying to "wind" the new ones in with a piece of threaded rod but this was not successful.18 KB (3,097 words) - 09:08, 11 January 2021