Search results

Create the page "Was" on this wiki! See also the search results found.

• Aftermarket part numbers (Jimny 2)
  The content of that web site was written by Americans based on Samurai vehicles which were sold in USA. Not
  543 bytes (75 words) - 15:00, 10 January 2021
• Transfer box from Suzuki SJ 410 - speedometer conversion
  ...tc as the original Jimny Speedo system. I used a “spare” output flange. It was roughly ”whittled” down to the same outside diameter as the original Ji ...ich I butted the gear up to. This helped it to stay straight. I checked it was running true by fit ting it to the TX box and spinning it round. When happy
  5 KB (884 words) - 14:32, 21 February 2019
• Improving and modifying a Jimny for mixed road and all terrain use
  ...in the process of restructuring improvements, each chapter (modification) was split off into its own standalone wiki article.''
  531 bytes (85 words) - 09:26, 20 September 2017
• Jimny history
  * The compact off-road capable Suzuki Jimny was Suzuki's first global success, lending it name recognition and a foothold i * This was built in "tin top" (Japanese) and a "soft top" / "hard top" cabrio (Built b
  4 KB (652 words) - 07:32, 10 February 2023
• Radio antenna replacement
  ...e was asking about reception problems and they commented that their aerial was (apparently) OK. * The one I bought was slightly thicker, so I could not use the original screws.
  5 KB (896 words) - 14:11, 21 February 2019
• Cabin filter change
  ...a five year old (heavily used) cabin filter of unknown manufacturer, which was removed from a Jimny 3. * That picture was unfortunately taken just '''after''' the leaves and grit were brushed off o
  5 KB (800 words) - 10:37, 17 January 2021
• Deep mud and deep water terrain
  ...atrol, or something else that was 3-6x more expensive than a Jimny when it was new.
  3 KB (496 words) - 12:18, 17 January 2021
• Rear upper spoiler installation
  * This guide was originally written by BigJimny forum user [http://www.bigjimny.com/index.ph ** It was transferred here by forum user [http://www.bigjimny.com/index.php/forum/pro
  10 KB (1,750 words) - 09:12, 27 November 2019
• Tie rod end replacement
  * However, I was lucky and it was possible to wind the joint off the rod without touching the locking nut.
  4 KB (632 words) - 13:32, 17 January 2021
• Clutch release bearing wash
  ...ease bearing slides on a shaft and the mud stops it. On the SJ series this was pretty much terminal as the access is limited to a small timing
  1 KB (250 words) - 13:34, 21 February 2019
• Jimny reviews and advertisements worldwide
  ...ideo or article does not correspond to the world region where the material was made. * This is a practical "real world" review, which was conducted with some proper all terrain driving in difficult conditions.
  12 KB (1,767 words) - 14:03, 21 February 2019
• Heated mirrors
  ...were introduced in 2006, at the same time when 2nd generation front bumper was introduced. However, it appears that heated mirrors were added as a factory
  2 KB (295 words) - 14:00, 21 February 2019
• Recovery points
  ...short rod together with the bow shackle was stuck in between, and the rod was welded to the tow point and to the tow bar. The bow shackle is now permanen
  9 KB (1,480 words) - 13:02, 17 January 2021
• Computerized vehicle failure diagnostics
  * OBD1 was used in the 1990s and early 2000s, while OBD2 (slowly) became used in the e * Before around 2001, Suzuki's proprietary protocol was called SDL (Serial Data Link).
  8 KB (1,228 words) - 15:19, 21 December 2020
• Bull bar (nudge bar)
  ...and regulations are got so strict by the time when 3rd model front bumper was introduced in 2012, that nudge bars became (almost) entirely illegal as new ...anese domestic models and some Brazilian models), any rear nudge bar which was made for Jimny 3 should be compatible with any Jimny 3.
  18 KB (3,032 words) - 07:47, 30 April 2020
• Gearbox R72 rebuild
  * This picture was taken on reassembly with a new sealed bearing on the counter shaft. * From the factory this was an open bearing on my 2009 model.
  10 KB (1,847 words) - 13:59, 21 February 2019
• Clutch replacement
  {{note|This article was written based on a RHD petrol Jimny configuration. LHD petrol Jimnys should * Mine was more of a problem as I have a switch panel fitted.
  18 KB (3,128 words) - 13:34, 21 February 2019
• Rear differential locker (Jimny 2)
  The reason for inclusion of the differential locker was legislative in nature. LJ80s, SJ410s and early SJ413s had a parking brake w
  3 KB (444 words) - 12:02, 12 January 2021
• Universal joint replacement
  * A factory fitted universal joint, removed from a Jimny produced in 2006 was <font face="courier">Koyo "KC1518CC-1 H"</font> ** It was removed from the rear propeller shaft where it connects to the rear differe
  11 KB (1,779 words) - 13:46, 17 January 2021
• Locking (anti-theft) wheel nuts
  ...protect all four road wheels), and learned the hard way later on why that was a mistake ... #* This product was used by forum user Bosanek and it is very high quality.
  10 KB (1,520 words) - 09:38, 15 February 2023

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)