BigJimnyMeet (North) 2024 (12 Jan 2024)
14th July 2024
Parkwood Nr. Leeds
Click HERE for details
Re:My 01 Jimny, another Norwegian
- mdog18
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- MadsV
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- Posts: 1767
- Thank you received: 332
- Points: 7185.00
They really should!MadsV wrote: New rear engine mount today
A bit messy with oil or something up there.
Mounted the castor correction bushes also
They really should come with the lift kit, its much better to drive, hardly any trailing compared to before!
Gearbox shaft seal leaking?
Norway 2005 Jimny M16A VVT, 235 BFG MT, 2" Trailmaster, ARB rear lck, 17%/87% high/low gears.
Please Log in or Create an account to join the conversation.
- MadsV
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- MadsV
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- MadsV
- Topic Author
- Visitor
-
Public
Hood and all cables off
Cleaned out the bell housing, was alot of oil spill there from the leaking engine. Pressure washed the rest of the engine bay.
Engines are on top dead center and ready to pull the cam sensor ring tomorrow.
Here are the two sumps, you can see that the small baleno one is wider than the jimny one. Cutting and welding them tomorrow! Hoping to maybe get it in the engine bay when saturday is over
Please Log in or Create an account to join the conversation.
- Posts: 8814
- Thank you received: 1761
- Points: 36277.00
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
Please Log in or Create an account to join the conversation.
- MadsV
- Topic Author
- Visitor
-
Public
Been all over the city looking for a bearing, but the shops that could have it are closed on saturday, of course.
Guess I can take my time getting everything ready, have to patch some rust holes also at the front thats not reachable when the radiator is in.
Here is the blanking plate for the rear of the head. Original with a rubber seal, metal gasket on the Baleno G16B. Sealed a little bit with rtv silicone also
Please Log in or Create an account to join the conversation.
- OlaGB
- Visitor
-
Public
Did you check the flywheel for wear, as it looked alittle worn on the pictures?
Please Log in or Create an account to join the conversation.
- MadsV
- Topic Author
- Visitor
-
Public
The clutch has had its days so I should consider changing the flywheel later on
Please Log in or Create an account to join the conversation.
- MadsV
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- MadsV
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.