anyone seen this rear disc conversion?

Thats an interesting design, by them editing it down to 3 minutes it made it hard to see how some aspects were achieved. Specifically the handbrake, they seem to have retained the existing backplate and then fitted a smaller brake shoe system to fit inside the disk to provide the handbrake. Also would be nice to see how the mount fits within the backing plate. Looks a bit as if it then uses standard disks and calipers from the front.

Seems to be a neat design.

I was also distracted by the bearing puller they had made up!

Roger Fairclough wrote: How not to remove a bearing.

Roger

If he was reusing it, I agree. If he is avoiding cutting it off, great idea

Sent from my Pixel 2 XL using Tapatalk